Thin Juice Causing Carto Flood

[VaporK]

I appear to be having issues with 555 Nobacco(not WOW) juice and flooding with a 3.0 SC carto. Probably spend more time unflooding tank than vaping, it wasn't a pleasant experience and juice was lost as well.

After doing some research, I determined the issue to be with the number of feed holes in carto and thickness of juice. I covered one of the feed holes with tape, and so far I haven't had any additional flooding issues but only time will tell. Also, the vapor is warmer, tastes better. After a lot of frustration, I'm enjoying the tank again.

Another alternative method for plugging, place a round toothpick in hole, snap off, and trim flush.

If you happen to be experiencing a lot of flooding, especially with certain juice, you want to try this solution.

[TheBlueAdept]

I have not had this issue, but if I did I would be in favor of the toothpick method. Id rather not vape the adhesive or the tape for that matter.

Sent from my phone; Please excuse typos / autocorrections.

[DemonFire]

Nice job VaporK! I'll remember that trick if I have that issue! Thanks!

[VaporK]

Don't use tape! The glue will dissolve. I'm attempting the toothpick trick now.

[HarmonyPB]

Thanks for the heads up VaporK! I have never had this issue, only the opposite, most of my juices are either just right or too thick. But I will keep this in mine for the future.

Sent from my phone using Swype...nuff said

[Snowdragon]

Hmmm...I use 3 hole DCCs for the most part and this is the first I have heard of this....but if it works, it works.

Nice save, thanks for sharing!